|Pypkote 2 mm is a Pipeline Corrosion Resistant Tape Confirming to IS 10221 Appendix B Specification. It Comprises of a tar based polumeric mix supported on a film of high tensile strength HMHDPE. The Polymeric mix is specially manufactured to have properties of high softening point, high penetration and high resistance to ageing. Tape is terminated on both exteriors by thermofusible HMHDPE Films which aids in the installation process. Pypkote 2 mm is available in widths of 500mm and 1000mm. Application is fast and easy. The pipe surface is first cleaned with a wire brush. IWL CS is applied on pipes immediately after cleaning. this is to prevent any further accumulation of rust on the pipe. After the primer is applied on the pipe, it is allowed to dry for about 30 minutes till it becomes touch dry. Before adhering the tape to the pipe, it is advisable to gently heat the CS coated pipe by a run of LPG torch. The bottom surface of the tape is heated by LPG Torch or any heat source. The tape is wrapped either by spiral or circumference method over the pipe. Overlaps are maintained with a minimum of 12 mm. A final coat of white wash is done immediately over the entire coated pipe. Over weld joints, the tape is applied after the necessary welding and testing of the joints are completed. the procedure for application of the tape is same as bare pipe procedure. Overlaps on each side of the weld joints are to be 50 mm. Pypkote 2 mm may also be applied as double layer system. In this case a second coat of IWL CS is applied over the first layer of Pypkote 2 mm tape. The CS is allowed to become touch dry. the bottom layer is HMHDPE film is removed from the tape by pulling it manually. The tape is thermo fused and wrapped over the primed surface of the first layer the first application. the overlaps are maintained at a minimum of 12 mm and sealed by thermo fusion. Weld joints are also similar double wrapped. Pypkote tape is recommended for application closer to the time of pipe erection and lowering inside trenches to avoid damages to Pykote. While in storage, pypkote rolls must be stacked properly under cover.
||Softening Point ° C
||65 to 121
||Penetration at 25° C, 100g, 5 Sec, dmm
||3 to 20
||20 to 30
||Does Not Drip at 100° C
||Tensile Strength , N/5cm, MinLengthwiseCrosswise
*Note : Price for per square meter inclusive of primer (Generally 1 liter primer is required per 8 SqM tape).